Needle Up/Down Position Button; Thread Cutter Button; Jog Dial; Confirm Button - Janome Horizon Memory craft 7700 QCP Instruction Book

LED signal
6
7
4
Press this button to bring the needle bar up or down.
The machine will stop with the needle up or down
depending on the position set by this button.
The LED signal is turned on when the down position is
selected.
5
NOTE:
The machine will always stop with the needle up after
4
sewing buttonholes, darning and monograms.
If you press the up/down needle position button when the
presser foot is at the extra lifted position, the LCD screen
will advise you to lower the foot.
5
Press this button after finishing sewing and the machine
will trim the threads automatically.
The LED signal blinks while cutting threads.
NOTES:
Use the thread cutter on the face plate when cutting
specialized threads or threads #30 or thicker.
Clean the auto thread cutter mechanism regularly to
avoid malfunction due to built up lint.
Avoid using a paper-cored spools with the auto thread
cutter. When nearly empty, they may not unwind
smoothly and cause the thread to bunch up or slip when
using the auto thread cutter (refer to page 10).
Do not pull the fabric if auto thread cutting fails and the
thread tangles. Turn the power switch off and remove
the needle plate to remove the tangled threads (refer to
page 89).
6
The jog dial is used for selecting stitch patterns,
characters and certain settings.
Turn the jog dial clockwise or counterclockwise with your
fingertip to browse patterns or settings.
7
Press the confirm button to select the desired pattern or
settings.
8

Needle up/down position button

Thread cutter button

Jog dial

Confirm button