Winding The Bobbin; Additional Spool Pin - Janome Sewing Machine Manual

q
z
w
x
e
c
v
b
q

Winding the bobbin

z Hold the thread with both hands and
pass the thread under the thread guide.
q Thread guide
x Guide the thread around the bobbin
winding thread guide.
w Bobbin winding thread guide
c Pass the thread through the hole in the
bobbin from the inside to the outside.
Put the bobbin on the bobbin winder
spindle.
v Push the bobbin winder spindle to the
right.
b Hold the free end of the thread in your
hand and start the machine.
Stop the machine when the bobbin has been
wound a few layers, and cut the thread close
to the bobbin.
n Start the machine again. When the bobbin
is fully wound, it will stop automatically.
Stop the machine and return the bobbin
winder spindle to its original position by
moving it to the left, and cut the thread with a
pair of scissors. Remove the bobbin from the
bobbin winder spindle.
NOTE:
The machine will not sew until the spindle has
been returned to the left.

Additional spool pin

The additional spool pin is for bobbin winding
without unthreading the machine.
q Additional spool pin
18