Table of Contents
Advertisement
2b
Connect to power & network
(Non-powered Ethernet network requires AC power adapter)
c
Connect the AC power
cable between the adapter
and an electrical socket.
Lower LED
lights green to
indicate adapter
has AC power.
a
Connect a network cable
to the DATA & POWER
OUT (or PHONE) port on
the adapter. The other end
goes to the LAN port on
the button box.
BB24 (button box)
Note: The button box can forward power to an IP phone but an IP phone cannot
forward power to a button box. Thus, if two devices will be daisy-chained, the
button box must be the first device in the chain. Keep in mind that if three or
more devices will be deployed, then one additional power adapter must be used
for every two devices.
6
b
Upper LED lights
green to indicate
when phone is
connected and
using power.
Connect the second network
cable to the DATA IN (or
NETWORK) port on the
adapter and an Ethernet
jack in the workspace (or on
a data switch/router).
Ethernet wall jack
IP 560 phone
Advertisement
Table of Contents
