Advanced Features - InFocus IN5312 User Manual

User's Manual

Advanced Features

Press the Menu button to open the OSD menu. Press ◄► to move to the Installation II menu. Press
▲▼ to move to the Advanced menu and then press Enter or ►. Press ▲▼ to move up and down in
the Advanced menu. Press ◄► to change setting values.
I
TEM
OSD Menu Setting
Peripheral Test
Lamp Hour Reset
Low Power Mode
3D
RS232
Network
Note:
Ensure that your video source is compatible with 3D source material.
Press Enter / ► to enter the OSD setting menu. See page 35 for more information on
OSD Menu Setting.
Press Enter/ ► to enter the Peripheral Test menu. See page 35 for more information
on Peripheral Test.
After replacing the lamp, this item should be reset. See page 36 for more information
on Lamp Hour Reset.
Press ◄► to turn Low Power Mode on or off. This affects power consumption when
the projector is in standby. When this feature is on, the projector will use less than 1
watt of electricity in standby mode. When this feature is off, the projector will use 9
watts of electricity in standby mode.
Press ◄► to disable or enable different 3D modes. See page 36 for more information
on the 3D menu.
Press ◄► to select RS232 (remote) or Network (LAN) mode depending on the pro-
jector connection method. Selecting RJ45 enables RJ45 control and disables the
RS232 port. Selecting RS232 enables RS232 control and disables the RJ45 network
port.
When RS232 control is enabled, the serial port settings are fixed to:
19200 Baud
8-bits
No parity
1 Stop-bit
No flow control
(Enter) / ► to enter the Network menu. See page 37 for more information on
Press
Network State.
D
ESCRIPTION
– 34 –