Cabling And Powering Up The Enclosure; Cabling The Enclosure; Cabling The Hp Bladesystem Onboard Administrator - HP BladeSystem c3000 Setup And Installation Manual

Cabling and powering up the enclosure

Cabling the enclosure

After all system hardware is installed, cable the components. See the HP ProLiant BladeSystem c-Class Site
Planning Guide on the Documentation CD or the HP website (http://www.hp.com) for additional cabling
and site planning requirements.
WARNING:
sure that all power is completely disconnected at the source before beginning any power
connections to the power bus bars or power bus box.
WARNING:
power components.
To cable the system:
Connect the Onboard Administrator modules.
1.
Connect the network cables to the interconnect modules. See the documentation that ships with the
2.
interconnect modules, or the HP ProLiant BladeSystem c-Class Site Planning Guide on the
Documentation CD or the HP website (http://www.hp.com/go/bizsupport).
Connect to the AC or DC power source in your facility and power up the enclosure.
3.

Cabling the HP BladeSystem Onboard Administrator

Item Connector
Enclosure
1
link-down port
To reduce the risk of electric shock or injury due to high-current electrical energy, be
Be sure that all circuit breakers are locked in the off position before connecting any
Description
Connects to the enclosure link-up port on the enclosure beneath it with a CAT5 patch
cable.
Cabling and powering up the enclosure 53