Warnings And Cautions - HP BladeSystem c3000 Setup And Installation Manual

131.5 kg
290 lb

Warnings and cautions

WARNING:
All troubleshooting and repair procedures are detailed to allow only subassembly/module-level
repair. Because of the complexity of the individual boards and subassemblies, no one should
attempt to make repairs at the component level or to make modifications to any printed wiring
board. Improper repairs can create a safety hazard.
WARNING:
• The leveling feet are extended to the floor.
The full weight of the rack rests on the leveling feet.
•
The stabilizing feet are attached to the rack if it is a single-rack installation.
•
The racks are coupled together in multiple-rack installations.
•
Only one component is extended at a time. A rack may become unstable if more than one
•
component is extended for any reason.
WARNING:
• Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at all
•
times.
Unplug the power cord from the power supply to disconnect power to the equipment.
•
Do not route the power cord where it can be walked on or pinched by items placed against it.
•
Pay particular attention to the plug, electrical outlet, and the point where the cord extends from
the server.
131.5 kg
290 lb
CAUTION:
clearance at the front and back of the server.
This symbol indicates that the component exceeds the recommended weight for one
individual to handle safely.
WARNING: To reduce the risk of personal injury or damage to the equipment, observe
local occupational health and safety requirements and guidelines for manual material
handling.
These symbols, on power supplies or systems, indicate that the equipment is supplied
by multiple sources of power.
WARNING: To reduce the risk of injury from electric shock, remove all power cords to
completely disconnect power from the system.
Only authorized technicians trained by HP should attempt to repair this equipment.
To reduce the risk of personal injury or damage to the equipment, be sure that:
To reduce the risk of electric shock or damage to the equipment:
WARNING: To reduce the risk of personal injury or damage to the equipment:
Observe local occupation health and safety requirements and guidelines for manual
•
handling.
Obtain adequate assistance to lift and stabilize the chassis during installation or
•
removal.
• The server is unstable when not fastened to the rails.
When mounting the server in a rack, remove the power supplies and any other
•
removable module to reduce the overall weight of the product.
To properly ventilate the system, you must provide at least 7.6 cm (3.0 in) of
Troubleshooting 77