HP BladeSystem c3000 Setup And Installation Manual page 62

The installation wizard displays the Check: Installation and Cables screen.
Verify all components are installed and connected.
8.
Select Continue, and press OK to begin checking for configuration and installation errors. When
9.
Continue is selected, the enclosure UID automatically powers off. If Push Settings = Yes:
The enclosure settings are pushed to adjacent enclosures
o
The installation wizards run on each adjacent enclosure
o
The enclosure UID powers off on the adjacent enclosures
o
If no errors are detected, the rear enclosure UID powers off, and the Insight Display screen illuminates
green.
Press OK to return to the Main Menu. Enclosure and blade hardware setup and configuration is
10.
complete.
IMPORTANT:
Summary screen displays. For more information on troubleshooting configuration errors, see
"Insight Display errors (on page 78)."
All configuration errors prevent the operation of the enclosure and should be corrected
immediately.
Open a browser and connect to the active Onboard Administrator module using the Onboard
11.
Administrator IP address that was configured during the Insight Display installation wizard process.
If errors are detected, the Insight Display screen illuminates amber, and the Health
Using the HP BladeSystem Insight Display 62