Bay Door; Bay Trim; Bay Louvers - Regency P48-LP Owners & Installation Manual

OPTIONAL BAY DOOR
The Bay louvers MUST be used
with the Bay glass option.
The optional Bay door is an overlay on the
flush front. The standard flush door and glass
must remain on the unit.
1) Unhook the 2 spring loaded hooks from the
bottom of the flush door.
2) Hook the top of the bay door over the flush
door flange and swing the bottom against
the bottom flange of the flush door.
3) Secure to the flush door bottom bracket with
2 screws provided.
Regency P48 Zero Clearance Direct Vent Gas Fireplace
4) Reconnect the 2 spring hooks securing the
flush door.
5) Slide the valve extension knobs onto the
valve knobs.
Note: If any maintenance etc. must be
done in the firebox, first remove
the Bay louvers and door.
Optional Bay Trim
Attach the supplied magnets each to the back
of the top and bottom trim pieces, and attach trim
to the top and bottom of Bay door. See diagrams
3 and 4.
Diagram 3
Diagram 4
INSTALLATION

BAY LOUVERS

1) Install top louver by sliding the two bracket
clips into the brackets located on top of the
bay door. See below. The fitted louver
leaves a small gap between faceplate
bottom and louver top.
Note: Top and bottom louvers and
brackets are different.
2) Install bottom louver by sliding the two
bracket clips into the brackets located un-
derneath the bay door. Install bottom louver
by sliding the two bracket clips into the
brackets located underneath the bay door
and secure with 1 screw on each end.
3) Open the bottom louver. Pull the Burner ON/
OFF control box from inside the bottom of
the fireplace. Using the 2 screws on the
louver, secure the control box in place.
Screws
on louver
bracket
Burner
ON/OFF
control
box
29