Log Set Installation; Door And Glass Frame - Regency C34-LP2 Owners & Installation Manual

LOG INSTALLATION
WARNING: Dangerous operating
conditions may occur if these logs
are not positioned in their approved
locations. Read the instructions
below carefully and refer to the
diagrams. If logs are broken do not
use the unit until they are replaced.
Broken logs can interfere with the
pilot and burner operation.
The gas log kit contains the following:
a) Front Log - Part # 902-180
b) Rear Log - Part # 902-186
c) Small Cross Logs (2) - Part # 902-182
d) Bag of embers - Part # 902-151
e) Bag of rockwool - Part # 902-153
(Part # 490-932 for the set of four logs)
1) Remove securing screw from bracket as
shown.
Diagram 1
DO NOT TRY TO TURN DOOR
HANDLE! IT IS NOT DESIGNED
TO BE MOVED.
Note: The door must be kept closed at all
times, except during maintenance.
The unit must never be operated
without the glass in the door, or
with the door open.
2) Remove the glass frame from the stove by
removing four nuts (support glass so it
doesn't fall out). See diagram 1.
3) Ensure that the front and rear deflectors are
installed.
4) Remove the logs from the box and carefully
unwrap them. The logs are fragile,
handle with care. Do not force into
position.
5) Place the rear log on the rear log support
pins in the back of the unit. The flat side of
the log facing the back of the unit. Carefully
Regency CLASSIC C34-2 Direct Vent Freestanding Gas Heater
push the log down onto the pins. See
diagram 3.
Diagram 2
6) Place the front log in the front of the unit,
aligning the holes on the underside of the log
with the log support pins in the front of the
unit. Carefully push the log down onto the
pins. See diagram 3.
7) Place the cross logs on top of the larger logs
aligning the holes on the underside of the
cross log with the log pins in the larger logs.
See diagrams 3 & 4. Carefully push the
cross logs onto the pins.
Diagram 3
Diagram 4
8) Distribute the embers along the mesh ember
tray but do not cover the burner ports.
(Burner ports are the little holes on the top
of the burner tube.) Pull off ember size
pieces from the rockwool. Gently place the
pieces on top of the embers. See diagram
5.
Do not put the rockwool directly on the
burner. Before putting the glass back on,
turn the unit on as per lighting instructions
pg. 29. Watch the flame to see if it flows
smoothly around from one end to the other.
INSTALLATION
Diagram 5
(Use Extreme Caution and ensure proper
light off of burner.)
Note: If the flame hesitates at any point,
check the area of hesitation and
see if there is an ember or rock-
wool blocking a burner port or
ports. If so, move the obstruction
and then check the flame flow
again.
9) Replace the glass. Secure door in the closed
position using the door securing bracket
and the screw provided, Figure 1. See door
and glass frame instructions.
Note: Door securing bracket is there for
safety.
DOOR AND GLASS
FRAME
1) The glass frame fastens with four 3/8"
nuts. See diagram 1.
Diagram 1
Note: The unit must never be operated
without the glass in place. (One
exception is made during the log
and ember installation.)
2) The securing bracket keeps the door closed.
25