Sanitizing Procedure - Following Cleaning Procedure - Hoshizaki KML-631MAH Service Manual

15) Move the service switch to the "DRAIN" position.
16) Replace the front panel in its correct position and turn on the power supply for
2 minutes.
17) Turn off the power supply and remove the front panel.
18) Move the control switch to the "ICE" position.
19) Replace the front panel in its correct position.
20) Turn on the power supply to fill the water tank with water.
21) Turn off the power supply after 3 minutes.
22) Remove the front panel.
23) Place the control switch in the "SERVICE" position. Then place the service switch in the
"WASH" position.
24) Replace the front panel in its correct position.
25) Turn on the power supply to rinse off the cleaning solution.
26) Turn off the power supply after 5 minutes.
27) Remove the front panel.
28) Move the service switch to the "DRAIN" position.
29) Replace the front panel in its correct position and turn on the power supply for
2 minutes.
30) Turn off the power supply.
31) Remove the front panel.
32) Repeat steps 18 through 31 three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 14 in "2. Sanitizing Procedure."
2. Sanitizing Procedure – Following Cleaning Procedure
1) Dilute approximately 1.25 fl. oz. (37 ml) of a 5.25% sodium hypochlorite solution
(chlorine bleach) with 2.5 gallons (9.5 l) of warm water.
2) Remove the insulation panel.
3) Pour the sanitizing solution into the water tank.
4) Move the service switch to the "WASH" position.
5) Replace the insulation panel and the front panel in their correct positions.
6) Turn on the power supply, and start the sanitizing process.
7) Turn off the power supply after 15 minutes.
8) Remove the front panel.
9) Move the service switch to the "DRAIN" position.
10) Replace the front panel in its correct position and turn on the power supply for
2 minutes.
11) Turn off the power supply.
53