Diagnostic Charts; Auxiliary Codes A-1 And Earlier - Hoshizaki C-100BAF Service Manual

F. Diagnostic Charts
The diagnostic charts below list possible reasons for problems with ice production and
shutdown. Before consulting the diagnostic charts, check for correct installation, proper
voltage per unit nameplate, and adequate water supply.

1. Auxiliary Codes A-1 and Earlier

No Ice Production - Possible Cause
1. Power Supply
2. Power Switch
3. Bin Control Thermostat Assembly
(with integrated heater)
NOTICE! Some units contain
a sticker that states: "The
bin control heater has been
disconnected. DO NOT
reconnect the bin control
heater." In this case, leave
the bin control heater
disconnected or replace
the bin control thermostat
assembly with 3A2561A03.
4. Optional Drain Pump HS-0248
Safety
1. Water Supply
2. Gear Motor
3. Suction Temperature Safety
(Low Water/Freeze-Up Safety)
4. Fan Motor
5. Compressor Relay
6. Compressor
Startup
a) Unplugged, off, blown fuse, or tripped breaker.
b) Not within specifications.
a) "OFF" position.
b) Bad contacts.
a) Open with bin filled with ice.
b) Ambient temperature too cool.
c) Out of position.
d) Out of adjustment. See "IV.C. Bin Control Check."
e) Bad contacts.
f) Bad thermostat heater (if applicable).
a) Open.
Freeze Cycle
a) Water supply off or improper water pressure.
b) External water filters clogged.
a) Gear motor external protector (2.4~3.0A) tripped.
b) Gear motor internal protector open or windings open.
c) Bad gear motor capacitor.
d) Locked bearings.
e) Spline coupling or gear broken and auger not turning.
a) Open due to water supply cut-off.
b) Open due to evaporator freeze-up (gear motor not operating).
c) Bad contacts.
a) Motor winding open.
b) Bearing worn out or locked rotor.
c) Fan blade does not move freely.
a) Open coil.
b) Open contacts.
a) Compressor external protector open or defective.
b) Motor winding open.
c) PTC relay contacts bad or coil winding open.
d) Inefficient.
33