Connecting Lcd Tv; Installing & Uninstalling Stand Base - Sanyo LCD-24K50 Instruction Manual

CONNECTING LCD TV

INSTALLING & UNINSTALLING STAND BASE
Please according to the following procedure to install stand.
1
Be careful of the panel. Suggest to put down the panel side on the cushion or other soft material before
installing the stand.
To align the corresponding pilot holes and fix the stand by screws.
2
Screws A for LCD-24K50/(R)/(W): 2 pcs
Screws B for LCD-24K50/(R)/(W): 2 pcs
3
Installing of stand is completed.
Model LCD-24K50/(R)/(W):
A
B
CAUTION IN UNINSTALLING STAND BASE
● Through in uninstalling work, handling with more than two people is recommended.
● When holding (moving or lifting) the LCD Display, hold the display's body. Do not handle the LCD
TV by holding the attached accessory parts (speakers), otherwise it may result in damage.
● Before uninstalling, provide a desk (or a part of it) which is strong enough to support the weight of
the LCD TV and this stand. The desk must be larger than the LCD Display screen size. The desk's
surface must be flat and maintained with soft material (such as a blanket) for protecting the screen
surface.
● Before putting the LCD Display on the desk, make sure there is no object on it. Leaving any object
under the screen may cause damage on the screen.
● The LCD TV with this stand should be uninstalled on flat and level place. Do not place on such as
an non flat, unlevel or unstable cart or stand. The display may fall, causing not only serious damage
to the products but serious injury to a person.
For correct installing, mounting and uninstalling LCD TV Stand, it is strongly recommended to use
a trained, authorized dealer. Failure to follow correct procedures could result in damage to the
equipment or injury to the installer.
8
SAFETY NOTE