Connecting Lcd Tv; Installing & Uninstalling Stand Base; Connecting Ac Power Cord - Sanyo LCE-24C100F(K) Instruction Manual

CONNECTING LCD TV

INSTALLING & UNINSTALLING STAND BASE
Please according to the following procedure to install stand.
1
Be careful of the panel. Suggest to put down the panel side on the cushion or other soft material before installing
the stand.
2 To align the corresponding pilot holes and fix the stand by screws.
Screws (M4x8) for LCE-24C100F(K)/(N)/(R)/(S): 2 pcs
Screw M4 X 8 :
Model LCE-24C100F(K)/(N)/(R)/(S):
Screw : M4 X 8
CAUTION IN INSTALLING & UNINSTALLING STAND BASE
● Through in installing or uninstalling work, handling with more than two people is recommended.
● When holding (moving or lifting) the LCD Display, hold the display's body. Do not handle the LCD TV by holding the attached accessory parts,
otherwise it may result in damage.
● Before installing or uninstalling, provide a desk (or a part of it) which is strong enough to support the weight of the LCD TV and this stand. The
desk must be larger than the LCD Display screen size. The desk's surface must be flat and maintained with soft material (such as a blanket) for
protecting the screen surface.
● Before putting the LCD Display on the desk, make sure there is no object on it. Leaving any object under the screen may cause damage on the
screen.
● The LCD TV with this stand should be installed or uninstalled on flat and level place. Do not place on such as a non flat, unlevel or unstable cart or
stand. The display may fall, causing not only serious damage to the products but serious injury to a person.
For correct installing, mounting and uninstalling LCD TV Stand, it is strongly recommended to use a trained, authorized dealer. Failure to follow
correct procedures could result in damage to the equipment or injury to the installer.

CONNECTING AC POWER CORD

This LCD TV uses nominal input voltages of 110-240V AC. This LCD TV
automatically selects the correct input voltage. It is designed to work with single-
phase power systems. To reduce risk of electrical shock, do not plug into any
other type of power system. Consult your authorized dealer or service station if
you are not sure of the type of power being supplied.
Connect the LCD TV with all peripheral equipment before turning the LCD TV on.
Note:
AC Power Cord types vary between countries.
CAUTION
For safety, unplug AC power cord when the LCD
TV is not in use.
6
3
Installing of stand is completed.
Screw : M4 X 8
SAFETY NOTE
AC POWER CORD
To the AC Outlet (110 - 240V AC).
Pulls the AC power cord out from
the LCD TV. The AC outlet must be
near this equipment and must be
easily accessible.