Raymarine HSB2 Plus Series Owner's Handbook Manual page 132

5-28
Adding Waypoints at the End of the Route
➤ To add waypoints at the end of the route:
1. Press the ROUTE soft key, followed by the EDIT ROUTE soft key.
The Make Route soft keys are displayed and the cursor is connected to the
last-placed waypoint with a dotted line. You can add further waypoints to
the route in the same way as for a new route.
2. Either:
i. Move the cursor to the required location, and press PLACE WAYPOINT
ii. Press USE WPT LIST , the MAKE ROUTE pop-up is displayed.
3. Place as many waypoints as required, and press the ACCEPT ROUTE soft key,
the default soft keys are displayed.
Note: You can UNDO waypoints in the original route, not just the new ones.
Removing a Waypoint from the Route
➤ To remove a waypoint from the current route:
1. Move the cursor over the required waypoint until the letters WPT are dis-
WPT
played. The waypoint soft keys are displayed.
2. Press the REMOVE WAYPOINT soft key. The waypoint is removed from the
route and the route is re-numbered.
Alternatively, you can remove the last waypoint from a route by pressing the
UNDO WAYPOINT soft key, as described above in Adding Waypoints at the End
of the Route on page 5-28.
If the route has not been saved and the waypoint was placed as part of the
route, the waypoint is erased.
If the route has been saved, or the waypoint existed before you created the
route, the waypoint remains on the screen.
soft key.
If you place the waypoint in the wrong position, press the UNDO WAY-
POINT soft key.
Or
Select a waypoint from the Waypoint List then press the INSERT WAY-
POINT soft key to place the waypoint at the end of the Route.
2
hsb PLUS Series Color LCD Display