Setting Up Your Device Codes - Radio Shack 15-1915B Owner's Manual

15-1915b.fm Page 7 Monday, July 19, 1999 12:06 PM
SETTING UP YOUR DEVICE
CODES
1. Refer to "Manufacturers' Codes" on Page 11
and write down the codes for your original
remote controls on the provided label.
2. Press the device key for the type of remote
you are replacing (
light blinks.
3. Hold down until the red light blinks twice,
P
then enter your 4-digit code.
Press
VOL s
VOL t
CHAN s
CHAN t
For example, to replace a Panasonic TV's
remote control (manufacturer code 1433),
press TV , hold P for two blinks, release, then
enter the 4-digit code.
VOL s CHAN
The red light blinks twice.
4. Point the Pocket Remote at your device and
press PWR . The device should turn on (or off,
if it was on).
Repeat Steps 2–4 for additional devices.
Notes:
• The red light at the top of the Pocket Remote
blinks twice when you enter a code that it
recognizes. (This does not mean that it is the
right code for your device.)
Need help? Call 1-800-950-7557
, , or ). The red
TV VCR CBL
For Number
1
2
3
4
t CHAN s CHAN s
7