Advertisement
7. Attach the two Front Uprights (4) to the two base rails (1 & 2) using the Upright Support Plates (6), eight
bolts (28), sixteen washers (18) and eight nuts (20) as shown. HAND TIGHTEN the bolts at this time.
8. Attach the two Pulley Support Frames (17) to the Front Uprights (4) and the Upright Guide Posts (10 & 12)
using eight bolts (22), sixteen washers ('18) and eight nuts (20) as shown. HAND TIGH-f EN the bolts at this
t i m e .
9. Attach the Upper Cross Brace (1 1 ) to the two Pulley Support Frames (17) using eight bolts (52), sixteen
washers (18) and eight nuts (20) as shown. HAND TIGHTEN the bolts at this time.
10. Tighten all bolts and nuts used for assembly in previous steps.
11 Carefully flex the Left Weight Bar Cables (24) onto the pulleys (27) so that the cables insert into the grooves
of each corresponding pulleys and insert the Left \ ieight Bar Knuckle (44) down through the rectangular
cutout in the Pulley Support Frame (17) and allowing the Left Weight Bar Knuckle (44) to hang free. Be sure
that the cables are straight and uncrossed and cables and pulleys move smoothly.
12. RFrpeat the step 1 1 on the right side of the PROSPOTlrrrrersrM
PC3000.
STEP #2: SENSOR WEIGHT BAR INSTALLATION
1.
Standing in front of the PROSPOTltzessrM PC3000. Insert one end and then the other end of the Sensor
\ Jeight Bar (25) into the Knuckles (42 & 44],. Slide the knuckles onto the Bar until they rest snugly against
the preinstalled sensor retaining collars (45 & 48) at each end of the Sensor Weight Bar (25). (There is a
rotation limiting pin that protrudes from the bottom of the Sensor Weight Bar (25) that must fit through a slot
in the knuckles (42 & 44) as it is slid into position)
2.
Place one Plastic Locking Sleeve (39) onto each end of the Sensoi Weight Bar (25) and slide them inwards
until they butt up against and secure the Weighi Bar Cable Knuckle in place. Tighten Plastic Locking Sleeve
boits securely.
3.
Piace one of the Olympic Adapters (30) onto the Sensor Weight Bar (25) and slide them onto the Bar until
they touch the Plastic Locking Sleeves (39) Insert an Olympic Adapter Retaining Plug (33) onto each end
of the Sensor Weight Bar (25) so that they also go Inside of the Olympic Adapters (30). Secure with two
Allen bolts (29) and two washers (36).
4.
Aitach the four small plastic pipes (15) to the two Pulley Support Frames (17) using four bolts (34), eight
washers (38) and four nuts (35) as shown. Tighten the bolts securely.
5.
Attach the eight Side Weight Plate Holders (14) to the two Front Uprights (4) using sixteen bolts (53), thirty-
tvro washers (18) and sixteen nuts (20) as shown. Tighten the bolts securely.
Note: In this manual when referring to Left and Right side of unit, the left and right perspective
are from the outside, facing the front of the unit.
--2--
Advertisement
