Onboard Serial Port 1; Onboard Parallel Port; Parallel Port Mode; Ecp Mode Use Dma - Fujitsu GA-8SGXP-FS P4 Titan Series User Manual

SiS Serial ATA Controller
Enabled Enabled onboard SATA controller. (Default value)
Disabled Disable this function.
SiS Serial ATA Mode
IDE Set onboard SATA controller function as IDE. (Default value)
RAID Set RAID function (two SATA drives necessary)
(for detailed information see SIS 964 SATA-RAID user manual)

Onboard Serial Port 1

Disabled Disable onboard Serial port 1.
3F8/IRQ4 Enable onboard Serial port 1 and address is 3F8. (Default value)
2F8/IRQ3 Enable onboard Serial port 1 and address is 2F8.
3E8/IRQ4 Enable onboard Serial port 1 and address is 3E8.
2E8/IRQ3 Enable onboard Serial port 1 and address is 2E8.
Auto BIOS will automatically setup the port 1 address.

Onboard Parallel port

Disabled Disable onboard LPT port.
378/IRQ7 Enable onboard LPT port and address is 378/IRQ7. (Default value)
278/IRQ5 Enable onboard LPT port and address is 278/IRQ5.
3BC/IRQ7 Enable onboard LPT port and address is 3BC/IRQ7.

Parallel Port Mode

SPP Using Parallel port as Standard Parallel Port.
EPP Using Parallel port as Enhanced Parallel Port. (Default value)
ECP Using Parallel port as Extended Capabilities Port.
ECP+EPP Using Parallel port as ECP & EPP mode.

ECP Mode Use DMA

This function will available when "Parallel Port Mode" set at ECP or ECP+EPP.
1 Set ECP mode Use DMA to 1.
3 Set ECP mode Use DMA to 3. (Default value)
- 41 - BIOS Setup