Table of Contents
Advertisement
Use the controls in the Setup menu to perform advanced image quality
adjustments and access various other PD520 features.
OSD Language: Select OSD Language from the Setup menu and press ENTER.
Then, use the up- or down-arrow buttons to select the OSD language (English,
French, Spanish, Portuguese or German). Press ENTER again to confirm your
selection.
PC Mode Adjust: To improve the quality of displayed images from a computer
or other VESA-compliant, RGB (480p or higher) source, select PC Mode Adjust
and press ENTER.
• Auto Adjust: Auto Adjust automatically adjusts settings to optimize computer
images. To execute Auto Adjust on command, select Auto Adjust and press
ENTER.
Auto Adjust may take some time to complete, depending
Note
on the characteristics of the incoming signal.
• Clock: Use the up- or down-arrow buttons (
use the right-arrow button (
left-arrow button (
• Phase: Adjust the phase if the image shows shimmer or "horizontal noise."
Pixel phase adjusts the phase of the pixel sampling clock relative to the
incoming signal. The effect of this control is similar to that of a tracking control
on a VCR.
For best results, use a good test pattern such as a smooth gray consisting of a
clear pattern of black and white pixels, or a similar "half on, half off" graphic
image. (You may notice that you can stabilize the image at more than one
point. Use either setting in this case.)
• H Position: Use the up- or down-arrow buttons (
Then, use the right-arrow button (
left-arrow button (
• V Position: Use the up- or down-arrow buttons (
Then, use the right-arrow button (
button (
) to shift the image down.
To restore the factory-default Clock, Phase and Position settings, select Factory
Reset and press ENTER.
Caption: Select Caption from the Setup menu to control the display of closed
captions when watching programs that contain them.
• Display: Select On or Off to control the display of closed captions.
• Mode: Select one of four captioning modes: CC1, CC2, CC3 or CC4. CC1
usually contains the native-language captions; if a program is captioned in
more than one language, those captions are carried on CC2, CC3 or CC4.
The PD520 also supports "text mode" captioning; to use this feature, select
Text1, Text2, Text3 or Text4. The text modes, instead of displaying a few lines of
captions somewhere on the picture, take over all or half of the screen to
display scrolling text information. (The text modes are seldom used today, so
most of the time there is no information there to see.) The text field is
sometimes used for embedding Internet data (called Interactive TV Links, or
ITV Links) in the captions.
Planar PD520 Owner's Operating Manual
) to increase the pixel clock rate; use the
) to decrease it.
) to shift the image to the right; use the
) to shift the image to the left.
) to shift the image up; use the left-arrow
,
) to highlight Clock. Then,
,
) to highlight H Position.
,
) to highlight V Position.
35
Setup
Setup
OSD Language
PC Mode Adjust
Caption
Letterbox Mode
Input Selection
Monitor Out
Overscan
Input Label
HDMI Audio
PC Signal
Film Mode
Auto Backlight
OSD Timer
Auto Off
HDMI CSC
LED
Advertisement
Table of Contents
