Connecting External Speakers (Optional); Connecting To A Dolby Digital Amplifier; External Speaker Connection; Digital Audio Connection - Planar PD520 Owner's Operating Manual

Connect the (positive) and
SPEAKER-R and SPEAKER-L terminals; see Figure 3-7. Connect speakers with an
impedance of 4 ohms. Maintain the correct polarity. For more information, refer
to the owner's manual for your speakers.
Twist exposed
wire strands
together.
Push tab to the
open position, and
insert the wire.
Then, close tab firmly to
secure the wire in place.
Figure 3-7. External Speaker Connection
If your home theater has a Dolby Digital amplifier or receiver, connect the
digital audio output from the PD520 to the digital audio input of the
amplifier/receiver as shown in Figure 3-8. The PD520 supports both coaxial
(S/PDIF) and optical (TosLink) digital audio connections.
The audio output level is fixed. (The volume and mute
Note
controls affect only the speaker and headphone outputs.)
Digital Audio Cable,
- or -
Optical
(Sold Separately)
Dolby Digital
Amplifier
Figure 3-8. Digital Audio Connection
Planar PD520 Owner's Operating Manual
(negative) speaker wires to the rear-panel
Right Speaker
Digital Audio Cable,
Coaxial
(Sold Separately)
Left Speaker
21
Connecting External
Speakers (Optional)
Connecting to a Dolby
Digital Amplifier