Arm Assembly - Weider PRO 4850 User Manual

12.Attach theTopFrame (6)between t heSquat U pright
(4)andtheSwivel U pright (5)withfourM10x95mm
Bolts (92), t hetwoShort F rame Plates (52),andtwo
M10Nylon Locknuts ( 87)asshown. Donottighten
the Bolts and Locknuts yet.
Attach the four Weight Guides (42) to the Top Frame
(6) with two M10 x 165mm Bolts (95), four M10
Washers (91), and two M10 Nylon Locknuts (87).
13. Press two 50mm x 75mm Inner Caps (58) into the
Top Frame (6) and the Butterfly Top Frame (7).
Attach the Butterfly Top Frame (7) to the Top Frame
(6) with two M10 x 70mm Bolts (85), two M10
Washers (91), and two M10 Nylon Locknuts (87).
Do not tighten the Locknuts yet.
Attach the Butterfly Top Frame (7) to the Butterfly
Upright (3) with two M10 x 95mm Bolts (92), two
M10 Washers (91), and two M10 Nylon Locknuts
(87).
Tighten all of the M10 Nylon Locknuts (87) used
in steps 2-13.
ARM ASSEMBLY
14. Open the parts bag labeled "ARM ASSEMBLY."
Press three 40mm x 50mm Inner Caps (21) into the
Leg Lever (10). Attach the Eyebolt (116) to the Leg
Lever with an M10 Washer (91) and an M10 Nylon
Locknut (87).
Lubricate an M10 x 65mm Bolt (59) with grease.
Turn the Leg Lever (10) so that the welded tab is
on the indicated side, and attach the Leg Lever to
the Seat Upright (9) with the Bolt and an M10 Nylon
Locknut (87). Do not overtighten the Locknut;
the Leg Lever must be able to pivot easily.
15. Press a 50mm x 70mm Inner Cap (34) into the
Butterfly Frame (47). Attach the tethers on the two
"L"-pins w/Tether (60) to the ButterfÊy Frame with an
M4 x 20mm Self-tapping Screw (14).
Lubricate a an M10 x 75mm Bolt (107) with grease.
Attach the Butterfly Frame (47) to the Butterfly Top
Frame (7) with the Bolt and an M10 Nylon Locknut
(87). Do not overtighten the Locknut; the
Butterfly Frame must be able to pivot easily.
12
92
13
58
14
15
52 i
i
87
21
21
=
i
34
87
"_ 107--Lubricate
,,' 14;
!
47
52
58
91
10