Weider MAX XP400 User Manual page 6

Attach a WheeU ( 31)totheoutside ofthe Base(1)
withanMIOx 78mmBoUt (81),threeMIO
Washers ( 75),andan MIONyUon Locknut ( 76).
Do not overtightenthe Locknut;the Wheel
mustbeableto turn
easily.
Attach the other Wheel (not shown} in the
same manner.
Orient the Cross Tube (11) as shown, with the
weUded tubes at the bottom. Attach the Cross
Tube and the Foot Hate (23) to the Upright (3)
with two MIO x 140mm Carriage BoUts(73), two
MIO Washers (75), and two MIO Nuts (47). Do
not insert a bolt into the upper hoJe in the
Foot Plate yet.
Press the Front Leg Foot (27) onto the bottom of
the Front Leg (6). Note that the front of the
Front Leg Foot is taller than the back.
Attach the Bench Rail (5), with the hook on the
bottom, to the Front Leg (6) with two MIO x
53mm Carriage BoUts(61) and two MIO NyUon
Locknuts (76).
Lubricate the MIO x 103mm BoUt (66) with
grease. Attach the Bench Rail (5) to the Upright
(3) with the BoUtand an MIO NyUon Locknut (76).
Do not overtighten the Locknut; the Bench
Rail must be able to pivot easily.
Tighten the Storage Knob (30) into the Upright (3)
and the Bench Rail (5).
76 75
75
Front
75 47
11
ied
Tube
Hook
76
Insert the bolt 76
through this hole "\,
Lubricate
6