Weider MAX XP400 User Manual page 10

15, Locate the fubrum on the Lat Tower (4) (see the
inset drawing), Slide the Tray (35) onto the rods
on the fubrum, Make sure the Tray is oriented
as shown in the drawing.
Set the Resistance Bars into the Tray (35) in the
following order: the lO-pound Resistance Bar (67),
the 20-pound Resistance Bar (36), an 80-pound
Resistance Bar (95), the lO-pound Center
Resistance Bar (44), an 80-pound Resistance Bar
(95), and the 40-pound Resistance Bar (96),
Orient the Cover Hate (72), with the edges up,
Attach the Cover Hate to the Tray (35) with two
M8 x 19mm Button Head Screws (86),
16, Locate the Long CabJe (80). insert one end of
the Cable through the welded tube on the indicat-
ed end of the Cross Tube (11) and then through a
Swivel Arm (22), if necessary, use the tip of a
screwdriver to pull the end of the Cable out of the
Swivel Arm, Make sure the CabJe is on the indi-
cated side of the welded rod in the Swivel Arm.
insert the Swivel Arm (22) into the welded tube
on the Cross Tube (11). Secure the Swivel Arm
with an M4 x 5mm Screw (8),
Wrap the Long Cable (80) around a 90mm Pulley
(28), Attach the Pulley inside of the Swivel Arm
(22) with an MIO x 42mm Button Head Bolt (71)
and an MIO Nylon Locknut (76),
17, Wrap the Long Cable (80) around a 90mm Pulley
(28), Attach the Pulley and a Cable Trap (29) to
the indicated MIO x 140mm Carriage Bolt (73)
with an MIO Nylon Locknut (76), Make sure the
CabJe Trap is oriented to hold the Cable in the
groove of the Pulley.
18, Attach a Pulley Housing (94) to the indicated "U"-
channel on the lO-pound Center Resistance Bar
(44) with an MIO x 102mm Button Head Bolt (24),
two Pivot Bushings (74), and an MIO Nylon
Locknut (76),
Wrap the Long Cable (80) around a 90mm Pulley
(28), Attach the Pulley inside of the Pulley
Rousing (94) with an MIO x 42ram Button Head
Bolt (71) and an MIO Nylon Locknut (76),
15
86
Edges
Up
35
80
1
28
24
8O
96
95
71
8
Rod
10