Weider Pro 900 User Manual page 8

7. 7
Press four 1" Square Inner Caps (12) into the
indicated ends of the Backrest Tubes (5, 55).
Press two 1" x 2" Inner Caps (45) into the ends of
the adjustment tubes.
With the wide end of the Backrest (6) positioned
as shown, attach the Backrest Tubes (5, 55) to
the Backrest (6) with four M6 x 38mm Screws
(16) and four M6 Washers (25). The Backrest
Tubes and Backrest must be oriented exactly
as shown.
8. Lubricate the M10 x 178mm Bolt (17). Attach the
Backrest (6) to the Frame (2) with the Bolt, two
M10 Washers (24), and an M10 Nylon Locknut
(19).
Secure the Backrest (6) to the Frame (2) with the
Adjustment Pin (40) through one of the three sets
of holes in the ad_stment tubes. Secure the
Adjustment Pin with the Pin Clip (57).
Make sure the Adjustment Pin (40) is com-
pletely inserted through both holes in the
adjustment tubes.
9. With the wide end of the Seat (11) positioned as
shown, attach the Seat to the brackets on the
Frame (2) with four M6 x 16mm Screws (15).
10. Attach the Curl Pad (28) to the Curl Post (27) with
two M6 x 16mm Screws (15).
Wide
End
12
16
ustment
_"25 Tubes
16
• 6
Tubes
2 %
"--_57
9
11
Wide
15
10
28
8