Weider Pro 900 User Manual page 12

ATTACHING WEIGHTS TO THE LAT TOWER
To use the Lot Tower (26), slide the desired amount of
weighl (not included) onto the weight tube on the
Weight Carriage (32).
ADJUSTING THE UPRIGHTS
The Uprights (1) can be adjusted to five heights to
accommodate different exercises. To adjust the
height, remove the M10 x 67ram Adjustment Knobs
(37) from both Uprights and Upright Bases (7). Slide
the Updghts to the desired position and re-insert the
Adjustment Knobs..
l_
I-i_jcll _
ATTACHING THE CURL POST
Note: When the Curl Post (27) is not iQ4Jse, the
-.45mm Square Inner Cap (21) should be inserted into
the Front Leg (8).
For some exercises, the Curl Post (27) must be
attached to the weight bench.
Slide the Curl Post (27) into the Front Leg (8). Align
one of the adjustment holes in the Curl Post with the
adjustment hole in the Front Leg. Tighten the MIO x
48ram Adjustment Knob (41) into the adjustment hole
in the Front Leg. Make sure that you fully tighten
the Adjustment Knob.
21
V
26J
32
i
::.i_tt'>"_ :}; Weight
12