Weider Pro 900 User Manual page 6

Before beginning assembly, carefully read the
following information and instructions:
• Place all parts of the weight bench in a cleared
area and remove the packing materials; do not
dispose of the packing materials until assembly
is completed.
• Read each assembly step before you begin.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART on the previous page. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
•l]ghten all parts as you assemble them, unless
instructed to do otherwise.
P
• As you assemble the weight bench, make sure
that all parts are oriented as shown in the draw-
ings.
THE FOLLOWING TOOLS (NOT INCLUDED)
ARE REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) phillips screwdriver
• One (t) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
• 1. Before assembling this weight bench, be sure
that you have read and understand the infor-
mation in the box above.
The weight bench is designed to be used with
a mid,width weight set (not included). To use
the weight bench with an olympic-size weight
set, an optional olympic expansion kit is avail-
able to purchase (model number 831.150780).
Position the Crossbar (3) as shown. (Note: If you
purchased the optional olympic expansion kit,
place the olympic crossbar in place of the stan-
dard crossbar.) Attach the Crossbar to each
Upright Base (7) with four M10 x 81mm Bolts
(43), a Support Plate (20) and four M10 Nylon
Locknuts (19). Note the position of the warning
decal and make sure the Upright.Bases are ori-
ented exactly as shown.
Slide the Uprights (1) into the desired position in
the Upright Base (7) and secure them with two
M10 x 67mm Adjustment Knobs (37).
2. Slide the welded bracket on the Frame (2) onto
the Crossbar (3). Secure the Frame with two M10
x 81mm Bolts (43) and two M10 Nylon Locknuts
(19).
19
3
6