Weider Pro 900 User Manual page 10

15. Secure the looped end of the Cable (34) to the
M19 x 19ram Bolt (46) and the bracket on the
Weight Carriage (32) with an M10 Nylon Locknut
(19).
Next, slide the Carriage Stop (39) onto the Lat
Tower (26). Secure the Carriage Stop with an M8
x 70mm Bolt (54) and an M8 Nylon Locknut (13).
Note: The Carriage Stop must be positioned with
the lip on top as shown.
16. Insert the Lat Tower (26) into the I_atTower Base
(35). Make sure that the I-at Tower is turned as
shown. Secure the Lat Tower with two M10 x
65mm Bolts (18), four M10 Washers (24), and
two M10 Nylon Locknuts (19).
17. Make sure that all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in USING
THE WEIGHT BENCH on pages l__and 12.
15
16
26
..... 24
10