Table of Contents
Advertisement
PAGE
19
WELDER
SPORTING
GOODS
25
73
79
25
[]
Next, fasten 3 112" PULLEYS
(51) to
PULLEY
BRACKETS
(28)
while
trapping the Cable into the Pulley with
CABLE
TRAP
BRACKETS
(42).
Again
the
Trap
Brackets
will
be
positioned
at a 45 degree angle facing
toward the front of the unit.
Bolt the
assemblies
to
the
PULLEY
BRACKETS
(28) using 318" X 1 3/4"
HEX
HEAD
BOLTS
(73)
and 3/8"
NYLON LOCK NUTS (79).
42
37
28
73
[]
[]
[]
BACKREST
FJ
Moving to the right-hand side of the unit, fasten the loop-end
of the Cable to the side of the Top Frame in the hole located
in front of the Arm Press Frame Upright.
Place a 112" X 112"
ZINC BUSHING
(9t) into the loop of the Cable.
Place a
5116" FLAT WASHER
(70) onto a 5116" X 3" HEX HEAD
BOLT (63) and insert through the assembled bushing and
Cable and on through the Top Frame hole secudng with
another 5/t6"
FLAT WASHER
(70) and a 516" NYLON
LOCK NUT (71).
.,
Move back to the center of the unit.
Into the
U-BRACKET
(26) bolted to the front of the ARM
PRESS FRAME UPRIGHT (4) assemble a 4 1/2"
PULLEY
(50)
trapping the Cable behind the
Pulley.
Secure with 318" X 1'314" HEX HEAD
BOLT (73) and 3/8' NYLON LOCK NUT (79).
5
At this point you should pull this Cable tight by
pulling downward on the section of the Cable you
left draped down in an earlier step. Make sure all
of the Cable is seated properly in the grooves of
the pulleys and the trap brackets are in their
correct positions.
63 7O
91
4
71
14
37
Hide quick links:
Advertisement
Table of Contents
