Table of Contents
Advertisement
STEP 6
WEIGHT
STACK
ASSEMBLY
PART NAME
QTY
110 END PLUG SELECTOR
1
114 LARGE RUBBER
WASHER
2
[]
CAUTION:
To aid in this step it is advised
that you secure the assistance of a helper to
assist in steadying
of the Weight Plates as
they are stacked.
Locate the LARGE
RUBBER
WASHERS
(114) atop the welded Guide Rod Bracket on
the BASE "T" (1).
[]
With the aid of your helper, begin stacking
the WEIGHT PLATES
(12) atop the Rubber
Washers on the Guide Rod Bracket on the
BASE (1).
Position
the Weight Plates with
the "Weider" embossing located to the rear of
the unit and the Weight Selector Pin holes to
the front of the unit.
[]
Stack Weights one at a time until all but one
are stacked on the Base.
[]
[]
Insert the END PLUG SELECTOR
(110) into
the bottom end of the WEIGHT SELECTOR
TUBE (13). Insert the Selector Tube into the
center hole through the stack
of Weight
Plates and align the Pre-assembled
Holl Pin
of the Selector
Tube with the groove in the
top of the Weight Plate.
NOTE:
The Weight Selector
Tube should insert completely
through the stack
of Weight
Plates
if they are in proper
alignment
with
the
welded
Guide Rod
Bracket
on the
Base.
If it does not insert
completely,
adjust the Weight
Stack positioning until it does.
12
When
the
WEIGHT
SELECTOR
TUBE
(13) has
been
inserted fully into the
Weight Stack, position the final
WEIGHT PLATE (12) over the
Selector Tube atop the Weight
Stack.
WEIGHT
SELECTOR
PIN HOLES
o
PAGE
10
WELDER
SPORTING
GOODS
PRE-ASSEMBLED
ROLL PIN
110
GUIDE ROD
BRACKET
Hide quick links:
Advertisement
Table of Contents
