Table of Contents
Advertisement
Using the remote control
Preparing
the
remote
control
for
use
With the remote control, you can operate your TV, most cable TV
converters/satellite
receivers, VCRs, and DVD players together, even if
they are different brands. If you will be using your TV with a Toshiba
satellite receiver, VCR, or DVD player, your remote control is already
programmed
and ready to use. If you own different brands of cable TV
converters/satellite
receivers, VCRs, and/or DVD players, you must
first program your remote control. (See "Programming
the
remote control to operate your other devices," on page 15.)
Installing
the remote
control
batteries
To install the batteries:
1. Open the battery cover on the back of the remote control.
Note:
The TV remote control may not operate your
VCR, DVD player, or cable TV converter.
Refer to the owner's manual suppfied with
your other devices to see which features may
be available.
Additionally, the remote control
for this TV may not support certain features
available on the original remote controls for
your other devices, in which case it is
suggested that you use the original remote
control for the appficable device.
Caution:
* Never throw batteries into a fire.
2. Install two "AAA" size batteries. Match the + and - signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.
Using the remote
control
to operate
your
Notes:
, Be sure to use AAA size batteries.
, Dispose of batteries in a designated disposalarea.
* Batteries shouldalways be disposedof with the
environment in mind.Always dispose of batteries in
accordancewith applicablelaws and regulations.
, If the remote control does not operate correctly,
or if the operating range becomes reduced,
replace batteries with new ones.
, When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or use
new and used batteries in combination.
* Alwaysremovethe batteriesfrom the remote control
if they are dead or if the remotecontrolis not to be
used foran extendedperiodof time.This will
preventbatteryacid from baking into the battery
compartmenL
other devices
To control
a cable TV
Power
converter/satellite
Input (TV) --
receiver:
Mute (TV) --
Channel
Program the remote
Numbers --
control to recognize the
CH RTN
brand of your cable TV
(Channel R eturn)--
converter/satellite
receiver
Channel/\ v --
(see "Programming
the
CBL/SAT --
remote control to operate
Volume +/- (TV) --
your other devices" on
Pic Size (TV) --
page 15.) The buttons
shown at right will control
the cable TV converter/
satellite receiver.
Press "CBL/SAT" first.
TV/VCR --
!iiiiiiiii ii!i
i i!ii!i i!ii!i
ii;ii!!!i!i
ii!_iii
To control
a VCR:
Program the remote
Input (TV)
Power
control to recognize
Channel
the brand of your VCR
Numbers
(see "Programming
the
CH RTN
remote control to
(Channel R eturn)
operate your other
VCR
devices" on page 15.)
Channel/\v
The buttons shown at Volume +/- (TV)
right will then control
Pic Size (TV)
the VCR.
Press "VCR" first.
VCR controls
14
J3W20221A(E)
P14-21
14
20/12/2005,10:48
AM
Advertisement
Table of Contents
