Table of Contents
Advertisement
Adding channels to the TV's memory
When you press Channel A / V on the TV or CH A / v on the remote
control, your TV will stop only on the channels you have programmed
into the TV's channel memory. Follow the steps below to program
channels into the channel memory.
Programming
channels
automatically
Your TV can automatically detect all active channels and store them in
its memory. After the TV has stored the channels in its memory auto-
matically, you can add or erase channels manually.
To add channels
automatically:
1. Press MENU, then press 4 or I1_ to display the SETUP menu.
2. Press A or V until the TV/CABLE
selection is highlighted.
_
_j
_
_
3. Press 4I or _ to highlight either
......
LANGUAGE
ENGLISH
TV or CABLE, depending on
which you use.
If you use an antenna, choose TV.
I_:SELECT
,__:AOJ UST
If you use cable, choose CABLE.
4. Press V until the CH PROGRAM selection is highlighted.
5. Press ",9or I_.to start channel programming. The TV will automatically
cycle through all the TV or Cable channels (depending on which you
selected), and store all active channels in the channel memory.
While the TV is cycling through the channels, the message
"PROGRAMMING
NOW-PLEASE
WAIT" appears.
6. When channel programming is complete, the message "COMPLETED"
appears.
7. Press CH/_ or v to view the programmed channels.
Adding and erasing
channels
manually
After you have programmed the channels automatically, you can add
or erase specific channels manually.
To add or erase channels
manually:
1. Press MENU, then press 4 or I_ to display the SETUP menu.
2. Press ,& or V until the ADD/ERASE
selection is highlighted.
3. Press _ or _ to display the ADD/
ERASE menu.
_j_
4. Press 4 or _ to select ADD/ERASE,
then press _.
L..............
CLOCK
SET
_,
5. Select
the desired
channel
to be
....o, P,o,,A,°
.........
memorized or deleted using A or V.
Press
4 or _. to select
ADD or
'_ .........
": ........
ERASE, whichever function you want
to perform.
6. Repeat step 5 for other channels you want to add or delete, then
press ENTER.
7. Press EXIT to return to the normal screen.
To erase all channels
from the channel
memory:
Press A, or V to select CLEAR ALL in step 2 above, then press ENTER.
All channels are deleted from the channel memory.
Changing
channels
To change to the next programmed
channel:
Press Channel A / V on the TV or CH A/v
on the remote control.
To change to a specific
analog channel:
Press the Channel Number buttons (0-9 and 100) on the remote control.
For example, to select channel 125, press 100, 2, 5.
To change to a specific digital channel:
Press the first 3 digits, then press 100, followed by the remaining 3 digits.
For example, to select channel 015-001, press 0, 1,5, 100, 0, 0, 1.
2O
Note:
If the desired channel is not stored in the
channel memory, proceed again the channel
programming.
Channel
Numbers
ChannelA
V
AT _
Menu
Exit
J3W20221A(E)
P14-21
20
20/12/2005,
11:43AM
Advertisement
Table of Contents
