Remote Controls - Heat & Glo PALOMA-BZ-MOD Owner's Manual

Hide thumbs Also See for PALOMA-BZ-MOD:
Table of Contents

Advertisement

J. Remote Controls
Tools Required: Powered screwdriver with Phillips head
bit; hex wrench; 7/16 in. wrench; manometer.
Disconnect electricity at the circuit breaker before begin-
ning this installation.
Familiarize yourself with the instructions enclosed with
the remote control kit.
Remote receiver
Remove the top plate from the appliance. Remove the
Allen head screws attaching the back panel to the appli-
ance. Retain screws.
Remove the front glass door assembly and the lower
access door.
Using two wire ties from the appliance component bag,
mount the remote receiver to the rear of the control panel.
Feed the red and orange wires to the front of the appli-
ance. Remove the optional blower, if installed.
Plug the 3-prong remote receiver cord into the junction
box (REM/AUX). Refer to Figure 8.29.
Plug the 2-prong blower cord directly into the 3-prong
polarized plug on the back of the receiver. This receptacle
output is 110/120 VAC, 3 AMP.
Attach the ground wire from the blower onto the ground-
ing clip.
Attach red wires from the remote receiver to the ON/OFF
switch.
Reinstall the blower into the blower bracket.
3 Prong Cord
3 Prong Cord
Figure 8.29
40
Heat & Glo • PALOMA-BZ-MOD, PALOMA-GR-MOD, PALOMA-GY-MOD • 2189-900 Rev. i • 5/12
Wires Ties
Wires Ties
Installing flame control solenoid
Remove the screw and knob from the variable regulator
and discard. Unscrew the nut from the regulator and
discard.
Remove the bag containing a washer and blue and red
plungers from the side of the flame control solenoid.
Place washer on flame control solenoid. Insert the correct
plunger (blue - Natural Gas, red - LP) into the flame
control solenoid.
Thread the flame control solenoid with the correct plunger
into the thread hole in the variable regulator. Turn one to
two turns only. DO NOT tighten or damage may occur.
See Figure 8.30.
GAS CONTROL
VALVE
WASHER
FLAME CONTROL
SOLENOID
VARIABLE
REGULATOR
WASHER
PLUNGER
Figure 8.30 Flame Control Solenoid
VARIABLE
REGULATOR
KNOB
SCREW
NUT
FLAME
CONTROL
SOLENOID
JAM NUT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Paloma-gr-modPaloma-gy-mod

Table of Contents