Table of Contents
Advertisement
D. Flue Dra t Considerations
Figure .1 on page
should:
building envelope. This helps to produce more draft,
the affects of wind turbulence and down drafts.
Exterior conditions such as roof line, surrounding trees,
prevailing winds and nearby hills can influence stove
area and can usually make suggestions or discover solutions
To be sure that your appliance burns properly, the chimney
draft (static pressure) should be approximately -.04 inch water
column (W.C.) during a low burn and -.10 inch W.C. during a
high burn, measured 6 inches (152mm) above the top of the
appliance after one hour of operation at each burn setting.
NOTE: These are guidelines only, and may vary somewhat
for individual installations.
E. Venting Systems
The venting system consists of a chimney connector (also
known as stove pipe) and a chimney. These get extremely
hot during use. Temperatures inside the chimney may
exceed 2000 F (1100
connector and chimney must be properly installed and
maintained.
connection is made through a combustible wall to a chimney.
is made through the ceiling to a prefabricated chimney.
These accessories are absolutely necessary to provide
safe clearances to combustible wall and ceiling material.
Follow venting manufacturer's clearances when installing
venting system.
Asphyxiation Risk.
March 21, 2013
Isle Royale Wood Stove
the chimney
WARNING
F. Tools And Supplies Needed
-
Before beginning the installation be sure that the following
tools and building supplies are available.
Reciprocating saw
Pliers
Hammer
Phillips Head Screwdriver
Flat Blade Screwdriver
Tape Measure
G. Inspect Appliance & Components and
re Burn Check List
1.
installation area and follow the procedures below:
2.
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect
all the parts and glass for shipping damage. Contact
your dealer if any irregularities are noticed.
3.
4.
This Owner's Manual has been read.
5.
Floor protection requirements have been met.
6.
Venting is properly installed.
7.
The proper clearances from the appliance and
chimney to combustible materials have been met.
8.
The masonry chimney is inspected by a professional
and is clean, or the factory built metal chimney is
installed according to the manufacturer's instruc-
tions and clearances.
9.
The chimney meets the required minimum height.
10.
11.
optional blower assembly.
Fire Risk.
Inspect appliance and components for damage.
Damaged parts may impair safe operation.
-
-
-
Report damaged parts to dealer.
250-5763F
Framing Material
Hi-Temp Caulking Material
Gloves
Framing Square
Safety Glasses
1/2 in. - 3/4 in. length, #6 or
#8 self drilling screws (need 3
per pipe section connection)
WARNING
R
Page 7
Advertisement
Table of Contents
