C. Outside Air it Installation
Included in it:
Items Needed or Installation: 4 inch (102mm) diameter
1
. Remove all materials from packing box.
over the intake air opening at the rear of stove using the
four mounting screws supplied with kit.
to accommodate outside air piping. Use 4 inch (102mm)
the unit or into vented crawl space.
a non-vented crawl space).
both ends. Use the supplied termination cap with a rodent
silicone to prevent moisture penetration.
FLEX FLANGE
Figure 13.1
NOTE: If you plan to install the optional blower and the
outside air kit, complete installation of the outside
air kit
.
March 21, 2013
Isle Royale Wood Stove
D. Installation Of Optional Blower
The blower is shipped fully assembled and ready
-
for installation.
1.
2.
-
3.
OUTSIDE AIR
TERMINATION CAP
(contains rodent screen)
Figure 13.2
250-5763F
Remove 3 Phillips head screws from rear of unit.
Using the Phillips head screws, attach blower to lower
rear of stove, as shown.
Plug blower cord into a grounded outlet. Do not remove
ground prong from plug. Route power cord to avoid
heat from the stove, or other damage. Do not route
cord under or in front of appliance.
*
Rear Shield
Blower Mounting
Flange
Blower Speed Control
Blower
Mounting
Flange
R
Rear
Shield
Page 13