Table of Contents
Advertisement
111-2300 (A)
4/6/08
To make a wide turn steer the mower with the handlebar in the direc-
tion required.
To make a tight turn (release the ground drive clutch lever, Autodrive
model), apply downward pressure on the handlebar to raise the front
wheels just above ground level and steer in the required direction.
To prevent accidents do not raise the front of the mower exces-
sively when making a turn. Never raise the rear of the mower
when the engine is running.
Release the ground drive clutch lever on auto drive models and push the
throttle control lever to the 'slow'
stop lever.
Emergency stop - If the engine fails to stop, disconnect the spark
plug lead.
To prevent engine damage do not use the mower on slopes greater
than 20 degrees.
Move the height of cut lever sideways to disengage it from the locking
notch, then push forwards to raise or pull backwards to lower the height
of cut. Release the lever in the required position and ensure that it locks
firmly into one of the eight notch settings.
Always select a height of cut to suit operating conditions. Prevent
engine overloading and blockages by avoiding low cuts in long grass
conditions. Be prepared to make two cuts when the grass is long.
11:27 am
Page 1.15
OPERATING
position. Then release the engine
Height of Cut
THE
MOWER
Turning
Stopping
Slopes
STOP
CS146
305113
CS284
1.15
Advertisement
Table of Contents
