Lanier LD225 Function Manual page 114

Initial Scanner Setup
❖ Wait Time for Next Original(s): SADF
When dividing originals and scan-
ning them separately with the
ADF to form a single file, select [Set
Wait Time] or [Continuous Wait] for
the waiting status.
Note
❒ This setting is valid if [SADF] is
specified for [Original Feed Type]
when scanning. For details, see
p.80 "Batch/SADF selection".
❒ If [Set Wait Time] is selected, en-
ter the wait time in seconds (3-
999) for placing additional orig-
inals with the number keys.
Scanning will start automatical-
ly if additional originals are
placed within this time. You can
end scanning and begin trans-
mission by pressing the {#} key
within this time. Once the spec-
ified time has elapsed, transmis-
sion starts automatically.
❒ If [Continuous Wait] is selected,
the machine will wait for the ad-
ditional originals until the {#}
key is pressed. Scanning will
start when additional originals
are placed and the {Start} key is
9
pressed. You can end scanning
and begin sending by pressing
the {#} key.
❒ Even if originals are placed on
the exposure glass, the machine
will operate according to the
specified settings. However,
every time originals are placed
on the exposure glass, you must
press the {Start} key to start
scanning.
❒ If a paper misfeed occurs or any
of the following operations is
performed while the machine is
waiting for additional originals,
the countdown stops and does
not start again until the {#} key
is pressed.
106
• Changing the settings such
as the scan settings
• Opening the upper cover of
the ADF
• Pressing the {Interrupt} key to
activate the copy mode
❖ Original Setting
Set the default for whether origi-
nals are one-sided or two-sided
and if two-sided, the relationship
between those sides. When the
originals are always the same, set
this for the default to make opera-
tion easier. You can select [1 Sided
Original], [2 Sided Orig.: T to T] (Top
to Top), or [2 Sided Orig.: T to B] (Top
to Bottom).
Reference
p.79 "Making the Settings Relat-
ed to the Orientation of the
Original and Scanned Sides"
❖ Switch to Batch
Select [SADF] or [Batch] as the scan-
ning mode that appears as [Original
Feed Type] in the initial display of
the scanner mode.
Reference
p.82 "Scanning Originals in Sev-
eral Times"
❖ Mixed Original Sizes Priority
This setting determines whether
the original size is to be automati-
cally detected when originals of
different sizes are inserted in the
ADF. You can select [On] or [Off].
Note
❒ If the original size is specified
when scanning, this setting is
ignored.