Lanier LD225 Function Manual page 107

Message
[Cannot specify any more scanning area.]
[Clear Misfeed(s) in ADF.]
[Communication error has occurred on the network.]
[Error has occurred in the scanner.]
[Error has occurred in the scanner driver.]
[Fatal error has occurred in the scanner.]
[Insufficient memory.
Close all other applications, then restart scanning.]
[Insufficient memory.
Reduce the scanning area.]
When a Message Is Displayed
Causes and solutions
The maximum number of scanning areas
that can be stored is 99. Delete unneeded
scanning area.
Remove jammed originals, and place
them again.
Check whether the originals are suitable
to be scanned by the machine.
Check whether the client computer can
use the TCP/IP protocol.
Check whether the scanning settings
made with the application exceed the set-
ting range of the machine.
• Check whether the network cable is
connected correctly to the client com-
puter.
• Check whether the Ethernet board of
the client computer is recognized cor-
rectly by Windows.
• Check whether the client computer
can use the TCP/IP protocol.
An unrecoverable error has occurred in
the machine. Call your service represent-
ative.
• Close all the unnecessary applications
running on the client computer.
• Uninstall the TWAIN Driver, restart
the computer, and then reinstall the
TWAIN Driver.
• Reset the scan size.
• Lower the resolution.
• Set with no compression. See TWAIN
Driver help.
Note
❒ "The Relationship between the Reso-
lution and the Scanning Area" chart in
Help for halftone scanning might not
always apply. Scanning cannot be per-
formed if large values are set for
brightness when using halftone or
high resolution.
❒ When a paper misfeed occurs in the
machine during printing, scanning
cannot be performed. In this case, af-
ter the misfed paper has been re-
moved, proceed with scanning.
8
99