When An Error Message Appears On The Client Computer - Lanier LD225 Function Manual

Troubleshooting

When an Error Message Appears on the Client Computer

This section describes the main possible causes and solutions for error messages
displayed on the client computer when the TWAIN Driver is used.
Note
❒ If an error message that is not included in this section appears, turn off the
main power switch of the machine, and then turn it on again. If the message
still appears, note the content of the message and the error number (if dis-
played), and contact your service representative. For information about how
to turn off the main power switch, see General Settings Guide.
Message
[Cannot add any more scanning mode.]
[Cannot connect to the scanner.
Check the network Access Mask settings in User Tools.]
[Cannot detect the paper size of the original.
Specify the scanning size.]
[Cannot find the scanner.
Check if the scanner main power is on.]
8
[Cannot find "XXX" scanner used for the previous scan.
"YYY" will be used instead.]
Note
❒ "XXX" and "YYY" indicate scanner names.
98
Causes and solutions
The maximum number of modes that can
be stored is 99. Delete unneeded modes.
The access mask is set. Consult the net-
work or scanner administrator.
• Place the original correctly.
• Specify the scan size.
• When placing an original directly on
the exposure glass, the lifting/lower-
ing action of the ADF triggers the au-
tomatic original size detection
process. Lift the ADF by more than 30
degrees.
• Check whether the main power
switch of the machine is turned off.
• Check whether the machine is con-
nected to the network correctly.
• Deselect the personal firewall func-
tion of the client computer.
• Use an application such as telnet to
make sure SNMPv1 or SNMPv2 is set
as the machine's protocol. For details,
see Network Guide.
• Check whether the main power
switch of the scanner used for the pre-
vious scan is turned off.
• Check whether the scanner used for
the previous scan is connected to the
network correctly.
• Deactivate the personal firewall of the
client computer.
• Use an application such as telnet to
make sure SNMPv1 or SNMPv2 is set
as the machine's protocol. For details,
see Network Guide.
• Select the scanner used for the previ-
ous scan.