Installation instructions
Unpacking
To ensure the best performance from your new AquaSmart™
clothes washer please follow the instructions below.
Removing the packaging
Remove the outer packaging.
1
Tilt the machine backwards and walk it off the bottom
2
packer one foot at a time.
Remove the bottom packer from under the machine by
3
pulling it out the front.
Lift the lid and remove the bowl packer from the bowl.
4
Remove the hoses and accessories.
5
Keep the bottom packer and bowl packer in case they are
6
required for future transit.
Important!
Ensure that the bottom packer has been removed before operating your machine.
Installation
In your clothes washer you will find:
4 rubber inserts for the levelling feet (joined
together).
hose guide.
white inlet hoses.
Drain hose
Carefully pull the drain hose out from the back of
1
the machine by pulling the exposed part of the
hose downwards and outwards.
To guide the drain hose over the tub or standpipe
2
the hose guide MUST be fitted to the drain hose.
To prevent siphoning:
The drain hose should not extend more than
0 mm from the end of the guide. The height of the
standpipe or tub should be between 850 – 400 mm.
The drain hose can be trimmed to length.
Place the drain hose in the tub or standpipe.
3
Draining
Regularly check that your standpipe or tub is free from lint or other obstructions, which may
affect how your machine works or may cause flooding.
In multi-storey apartments or any upper floor, the machine should be installed on a drained floor.
Draining must comply with local by-laws.
Fig.1 Tilt washer backwards
to remove packer
Pull hose
through guide
Flex hose
guide apart
Fig.2 Fitting the drain hose guide
(0 mm)
maximum