Fisher & Paykel RX216 Installation Instructions And User Manual page 9

Close doors.
3
Remove top hinge covers by removing
4
Phillips screws.
Unscrew 5⁄16" (8 mm) hex head screws from
5
top hinges.
Detach main wire connector harness.
6
Do not remove screw connecting green
ground wire.
To detach main wire harness, use a flat
blade tool or fingernail to press junction
point between two connectors to release.
Remove top hinges along with doors.
7
Remove bottom hinges with a 3⁄8" (9.5 mm)
8
hex head driver.
Replacing the doors
To replace the doors, follow the steps in
door and hinge removal in reverse order.
Important!
If water line tube end is damaged, cut off
5⁄8" (16 mm) before reconnecting.
Installation instructions
Fig.2 Door and hinge removal
Step 4
Step 6
Step 7
Step 8
7
EN