NordicTrack Revitalize inversion system 2.0 831.14895.1 User Manual page 8

,
Attach the Support Bracket (15) to the Center
Base (3) with two M4 x 15mm Screws (58).
3
,
Attach the Center Base (3) to the Left and
Right Bases (1,2) with four M10 x 80mm
Button Bolts (52), four M10 Curved Washers
(50), and four M10 Locknuts (65). Do not
tighten the Locknuts yet.
4
65
2
1\
,
See the inset drawing. Identify the Center
Frame (7).
Apply some of the included grease to both
sides of the Left Large Spacer (31).
Attach the Left Large Spacer (31) and the Left
Frame (4) to the Center Frame (7) with an
M10 Locknut (65), an M10 Large Washer
(64), and a 29mm Spacer (48).
Then, press an 89mm Cap (32) into the
Center Frame (7).
Repeat this step with the Right Large
Spacer (60) and the Right Frame (5).
5
32
65
64
Grel
31
8