NordicTrack AudioStrider R400 NTEX4196.0 User Manual page 5

Whileanother person liftstherearofthe Frame (1),
attach the RearStabilizer ( 16)to theFrame withfour
M8x 50mmButton Screws (52)andfourM8Split
Washers (55).
3. Tighten the Upright K nob(7)intothe Frame (1).
4. Whileanother p erson holds the Upright ( 2)nearthe
Frame (1),usethewiretie in theUpright t o pullthe
Upper WireHarness (42)through theUpright. S eethe
insetdrawing.Tietheendof thewiretie totheUpper
WireHarness. Then,pulltheotherendofthewiretie
upward outof thetopofthe Upright. R emove anddis-
cardthewiretie.
AttachtheUpright ( 2)tothe Frame (1)withan
M10x 63mmBoltSet(62).Becarefulto avoid
pinching the Upper Wire Harness (42).
The Console (4) requires four "D" batteries
(not included); alkaline batteries are recommended.
Remove the battery covers from the back of the
Console. Next, insert four batteries into the battery
compartments; make sure that the batteries are ori-
ented as shown by the diagrams inside the battery
compartments. Then, reattach the battery covers.
Note: The Console (4) can be operated with an
optional power supply instead of batteries. To pur-
chase a power supply, call the tolFfree telephone
number on the front cover of this manual. Plug one
end of the power supply into the jack at the front of
the exercise cycle. Plug the other end of the power
supply into an appropriate outlet that is properly
installed in accordance with all local codes and ordi-
nances.
Avoid pinching
and damaging
the wire harness.
62
55
52
52
Batteries
4\
62
Battery
Covers
/ Batteries
5