Assembly - NordicTrack AudioStrider NTEL7906.3 User Manual

ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
in addition to the included tool(s), assembly requires a Phillips screwdriver _ and a rubber
mallet c__.
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parenthe-
ses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The
number following the parentheses is the quantity needed for assembly. Note: If a part is not in the hardware
kit, check to see if it has been preassembled.
M8.5 x 16mm x
M6 Split Washer M8 Split 1.5mm Washer M10 x 25mm M10 Curved
(102)-8 Washer (101 )-4 (103)-6 Washer (87)-2 Washer (99)-4
1
Link Arm
Spacer (74)-4
M4 x 16mm M6 x 35mm M6 x 62mm
Wave Washer Screw (116)-16 Screw (109)-4 Screw (108)-4
(100)-2
M8 x 15mm Button
Screw (106)-10
M8 x 20mm Button
Screw (107)-4
M8 x 25mm Button
Screw (110)-2
M10 x 20mm Button
Screw (111)-2
M10 x 93mm Button Screw (82)-4
.
If there is a shipping bracket attached to the
rear of the Folding Frame (not shown), remove
the screw and the shipping bracket from the
Folding Frame. Discard the screw and the ship-
ping bracket.
See HOW TO FOLD AND UNFOLD THE
ELLiPTiCAL EXERCISER on page 11 and
unfold the elliptical exerciser.
While another person lifts the front of the
Frame (1), attach the Front Stabilizer (4) to the
Frame with two M10 x 93mm Button Screws
(82) and two M10 Curved Washers (99).
5