Table of Contents
Advertisement
ASSEMBLY
Assembly requires two people. Set the treadmillin a cleared area and remove all packing materials. Do not
dispose of the packing materials untilassembly is completed. Assembly requires the included allen wrenc_
and your own phillips screwdriver _
and wire cutters _.
Note: The underside of the treadmillwalking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (69) until the treadmill is in the position shown.
Refer to the inset drawing. Insert one of the Extension
Legs (102) intothe treadmill as shown. Make sure that
the Extension Leg is turned so the Base Pad (99) is be-
neath it. Note: It may be helpfulto tip the Uprights(69)
forward as you insertthe Extension Leg.
Insert the otherExtensionLeg (not shown)in the same
way.
99
2. Press the Latch Knob Sleeve (70) intothe left Upright (69).
Make sure that the Latch Pin Collar (72) and the Spring
(71) are on the Latch Pin (74). Insert the Latch Pin into
the Latch Knob Sleeve (70) and the left Upright (69).
Press the Latch Knob Spacer (35) onto the other side of
the left Upright. Then, tighten the Latch Knob (68) back
onto the Latch Pin.
2
68
70
71
72
74
3. With the help of a second person, carefully tip the
Uprights (69) down as shown. Make sure that the
Extension Legs (102) remain in the Uprights.
Attach each ExtensionLeg (102) with two 314"Screws
(100).
With the help of a second person, carefully tip the
Uprights(69) back to the vertical position.
Note: One replacement Base Pad (99) may be included.
Use the Base Pad to replace any Base Pad that becomes
worn.
69
99-
_102
6
Hide quick links:
Advertisement
Table of Contents
