10. Apply grease to a Link Arm Axle (94).
Insert the Link Arm Axle (94) into the Right Upper
Body Leg (6) and the Right Link Arm (90) from
the side shown.
Insert a hex key into the M8 x 25mm Screw
(128) in the Link Arm Axle (94).
Using a second hex key, tighten another
M8 x 25mm Screw (128), a Pivot Axle Cover
(111), and an M8 x 25mm x 1.5mm Washer (126)
into the other end of the Link Arm Axle (94).
Tip: Avoid damaging
the Pivot Axle Cover
when tightening
the Screw.
Repeat this step on the other side of the
elliptical.
10
91
90
126
128
11. Tighten the six M8 x 45mm Bolts (104) and
the eight M8 x 16mm Screws (102).
Press the Top Cover (23) into the Right and Left
Frame Covers (21, 22).
11
102
21, 22
104
11