Grill Cart Assembly; Wheels And Bottom Panel Assembly - Nexgrill 720-0718B Assembly & Operating Instructions

UNPACKING
CAUTION: Obtain the aid of an assistant when handling
large or heavy grill components.
1. Once the top of shipping box is open, obtain the aid of an
assistant.
2. Remove all packing materials from around grill exterior.
3. Open both Firebox lids and remove packing materials
and components inside each Firebox chamber.
4. With the aid of an assistant, lift the Firebox from the
bottom of the shipping box and place on protected fiat
surface. Be careful not to damage hose and regulator.
5. Remove grill bottom panel from bottom of shipping box.
6. Refer to the Parts Lists to check that all parts are present.
7. Inspect the grill for damage as you assemble it. Do not
assemble or operate grill if it appears damaged. If there are
damaged or missing parts, call the Grill Information Center
at 1-800-913-8999 in USA and 1-800-648-5864 in Canada.
1. Grill Cart Assembly.
IMPORTANT: As an aid to assembly, see the Package
Contents List and Hardware Pack Contents on pages 5, 6,
and 7 for pictures and sizes of grill components and
fasteners referenced by key letters in these instructions.
a). Attach 2 Insert Glides(H) to cart leg, front left (B) and
cart leg, back left (C). See Fig. 1.
b.) Use 4 CC round head screws and 4 DD lock washers to
attach cart brace, left (D) to cart leg, front left (B) and cart
leg, back left (C). See fig 1.
NOTE: Use Tab on Cart Leg, Front Left as indicator of
Front Side of Grill during assembly.
c). Use 4 CC Round Head Screws and 4 DD Lock Washers
to attach Cart Brace, Right (G) to Cart Leg, Front Right (E)
and Cart Leg, Back Right (F). Attach Cart Brace, Right (G)
so that flat side will face cart interior and wide lip faces
down. See Fig. 2.
2. Wheels and bottom panel Assembly
a). Insert Wheel Axle (K) through Cart Leg, Front Right (E)
and Cart Leg, Back Right (F). Place Wheels (L), cone side
facing Leg, on each end of Axle. Secure Wheels to Axle
with 2 FF Nut and 2 GG Flat Washer. See Fig. 3.
b.) Use 4 HH round head screws and 4 GG flat washers to
attach cart leg, front left (B) and cart leg, back left (C) to
bottom panel (J), repeat the step to attach Cart Leg, Front
Right (E) and Cart Leg, Back Right (F) to bottom panel (J).
See Fig.4.
Note: Use Tank Hole on bottom panel as indicator of Right
Side of Grill during assembly.
10
Screws and washers
shown here are
behind of D
B
C
------- H
Fig.2 G
\
E iii
F
Fig. 3
F
K
Fig. 4
C