Advertisement
/
31
See the aboveinformationon
how to use the Locaior Code
Buttonfor Programming.
For most homes this step woul_
not be needed but for your
information:
Up to 9 different remote locator
address codes can be set on which the
TV can send out its "homing" signal
This is done in case there is more than
one 73/(with a remote locator)
7resent, and you want only one
specific remote to be signaled when the
TV is turned ON.*
To set a Locator Address Code:
<_
With TV turned ON, press the
LOCATOR CODE button on the
remote. (Also be sure the TV
SYSTEM button on the remote has
been pressed.)
You will need a pencil or pen to press
the recessed button.
The TV shows the present Remote
Locator Code.
<_
Press any
button (0-9)
number
the remote to set or change the Locate,.
Code.
The remote will beep to let you know
it has received the new Locator Code
and then return to its normal operating
mode.
Remember, if batteries are
replaced the Locator Code
will need to be reentered.
When setting the Locator Code if any
button, other than the number buttons,
are pressed the remote will return to
its normal operation mode.
*For owners who live in fin apartment
(townhouse or condominium)
complex, this task may be necessary
since the remote locator's signal can
be sent and detected directly through
adjoining walls.
Advertisement
