Troubleshooting Tips - Hotpoint HTDX100EM0WW Owner's Manual

Before you call for service...
R
Troubleshooting Tips
Save time and money! Review the charts on the following
pages, or visit Hotpoint.com. You may not need to call for
service.
Problem Possible Causes What To Do
Dryer doesnt start Dryer is unplugged , Hake sure the dryer plug is pushed completely into
the outlet.
Fuse is blown/circuit breaker , Check the house fuse/circuit breaker box and replace
is tripped fuse or reset breaker. NOTE:Electricdryers use two fuses
or breakers.
Dryer doesn't heat Fuse is blown/circuit breaker , Check the house fuse/circuit breaker box and replace
is tripped, the dryer may both fuses or reset both breakers. Your dryer may tumble
tumble but not heat if only one fuse is blown or one breaker tripped.
Gas service is off
,
Make sure gas shutoff at dryer and main shutoff are
fully open.
LP gas supply tank is empty , Refillor replace tank. Dryer should heat when
or there has been a utility utility service is restored.
interruption of natural gas
(gas models)
Dryer shakes or Some shaking/noise is normal. , Move dryer to an even floor space, or adjust leveling legs
makes noise Dryer may be sitting unevenly as necessary until even.
Greasy spats an clothes Improper use of fabric softener • Follow directions on fabric softener package.
Drying dirty items with , Use your dryer to dry only clean items. Dirty items can
clean ones stain clean items and the dryer.
Clothes were not , Sometimes stains which cannot be seen when the
completely clean clothes are wet appear after drying. Use proper
washing procedures before drying.
Lint an clothes Lint filter is full , Clean lint screen before each load.
Improper sorting , Sort lint producers (likechenille)from lint collectors
(like corduroy).
Static electricity can attract lint • See suggestions in this section under STATIC.
Overloading • Separate large loads into smaller ones.
Paper, tissue, etc. left in pockets , Empty all pockets before laundering clothes.
Static occurs No fabric softener was used , Try a fabric softener.
e
Bounce® Fabric Conditioner Dryer Sheets have been
approved for use in all GE Dryers when used in
accordance with the manufacturer's instructions.
Overdrying , Try a fabric softener.
, Adjust setting to LESSDRYor DANP DRY.
Synthetics, permanent press , Try a fabric softener.
and blends can cause static
Inconsistent drying times Type of heat , Automatic drying times will vary according to the type
of heat used (electric, natural or LP gas),size of load,
types of fabrics, wetness of clothes and condition of
exhaust ducts.
10