Hotpoint HTDP120GDWW Dimensions And Specifications
Hotpoint HTDP120GDWW Dimensions And Specifications

Hotpoint HTDP120GDWW Dimensions And Specifications

Hotpoint 6.8 cu. ft. capacity duradrum gas dryer
Hide thumbs Also See for HTDP120GDWW:

Advertisement

Side View
HTDP120GD – Hotpoint

Dryer Dimensions (in inches)

23-1/2
25-3/4
25-1/2*
4-3/4
Side View
* 24-1/2" from the edge of the side panel to the front.
25-1/2" from front to edge of end caps.
HTPWasher/Dryess LC QSart
Specification Created 1/12
470163
Rear View
6.8 cu. ft. capacity DuraDrum
®
27
42
11-3/4
36
2
2-1/2
Rear View

gas dryer

Exhaust Options:

3-way via rear, left and bottom. Dryer is shipped exhausted to the rear. Alternate exhausting
knockouts are supplied.

Circuit Requirements:

An individual properly-grounded branch circuit, with a three-prong grounding-type receptacle,
protected by a 15- or 20-amp circuit breaker or a time-delay fuse is required.

Gas Dryer Electric Rating:

120V, 60Hz, 6 Amp
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas. LP gas supply
requires an optional conversion kit. Check installation instructions for correct kit and have a
qualified gas technician install a conversion kit. See dryer ducting information for proper
installation.
Installation Information: For complete information, see installation
instructions packed with product for current dimensional data.

Special Installation Requirements

Alcove or Closet Installation:

• If your dryer is approved for installation in an alcove or closet, it will be stated on a
5-1/2
label on the dryer back.
• The dryer MUST be exhausted to the outside.
• Minimum clearances between dryer cabinet and adjacent walls or other surfaces are:
0" either side
3" front and rear
• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52" .
• Closet doors must be louvered or otherwise ventilated and must contain a minimum of
60 sq. in. of open area equally distributed. If this closet contains both a washer and a
dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.
• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.

Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors.
• The installation must conform with the local codes, or in the absence of local codes,
with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

Minimum Clearances other than Alcove or Closet Installation:

• Minimum clearances to combustible surfaces
0" both sides
3" rear

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HTDP120GDWW and is the answer not in the manual?

Questions and answers

Summary of Contents for Hotpoint HTDP120GDWW

  • Page 1: Gas Dryer

    Side View Rear View HTDP120GD – Hotpoint 6.8 cu. ft. capacity DuraDrum gas dryer ® ™ Exhaust Options: Dryer Dimensions (in inches) 3-way via rear, left and bottom. Dryer is shipped exhausted to the rear. Alternate exhausting knockouts are supplied.
  • Page 2 HTDP120GD – Hotpoint 6.8 cu. ft. capacity DuraDrum gas dryer ® ™ Dryer Exhausting Information – Use Metal Duct Only Vertical and Horizontal Ducting For complete information, see installation instructions packed with your dryer. Best Performance Ducting Materials: Maximum Length of For best performance, this dryer should be vented with 4"...
  • Page 3 • Upfront lint filter makes cleaning out lint easy • 4 heat selections provide the right temperatures for your clothes-drying needs • 6 dry cycles—additional cycles for your clothes-drying needs • Model HTDP120GDWW – White on white Specification Created 1/12 470163...

This manual is also suitable for:

Htdp120gd

Table of Contents