Loading And Using The Dryer - Hotpoint HTDX100EM0WW Owner's Manual

Loading and using the dryer.
Always follow the fabric manufacturer's care label when laundering.
Sorting and Loading Hints
As a general rule, if clothes are sorted properly for the Do not overload. Thiswastes energy and causes
washer,they are sorted properly for the dryer, wrinkling.
Do not add fabric softener sheetsonce the load has
become warm. They may cause fabric softener stains.
Bounce® Fabric Conditioner Dryer Sheetshave been
approved for use in all GEDryers when used in
accordance with the manufacturer's instructions.
Do not dry the following items: fiberglass items,
woolens, rubber-coated items, plastics, items with
plastic trim and foam-filled items.
Careand Cleaning of the Dryer
The Exterior: Wipe or dust any spills or washing
compounds with a damp cloth. Dryer control panel
and finishes may be damaged by some laundry
pretreatment soil and stain remover products. Apply
these products away from the dryer. The fabric may
then be washed and dried normally. Damage to your
dryer caused by these products is not covered by
your warranty.
The Exhaust Duct: Inspect and clean the exhaust
ducting at least once a year to prevent clogging.
A partially clogged exhaust can lengthen the
drying time.
Follow these steps:
rl] Turn off electrical supply by disconnecting
the plug from the wall socket.
The Lint Filter: Cleanthe lint filter before each use.
Moisten your fingers and reach into the filter opening.
Runyour fingers acrossthe filter. Havea qualified
technician vacuum the lint from the dryer once
a year.
-2-]Disconnect the duct from the dryer.
r_] vacuum the duct with the hose attachment
and reconnect the duct.
TheExhaust Hood: Checkfrom the outside that the
flaps of the hood move freely when operating. Make
sure that there is no wildlife (birds,insects,etc.)nesting
insidethe duct or hood.
J
8