Accessories; Accessories Supply; Remote Control Batteries - Panasonic TH-42PF20W Operating Instructions Manual

Accessories

Accessories Supply

Check that you have the accessories and items shown
Operating Instruction book
Power supply cord

Remote Control Batteries

Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon" with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, ¿ re or the like.
Remote Control
Transmitter
N2QAYB000432
2. Insert batteries - note correct
polarity ( + and -).
"R6" size
-
+
Clamper × 3
TMME289
Use the Ferrite cores to comply
with the EMC standard.
(see page 59)
3. Replace the cover.
+
-
Batteries for the Remote
Control Transmitter
(R6 Size × 2)
Ferrite core × 2
J0KG00000146 (Set of 2)
7